Close a stopper of discharge of cooling liquid from a radiator and the discharge crane from the block of cylinders. Install into place
Install the handle of management of a heater in the provision of the maximum heating.
Slowly fill in in a radiator fresh cooling liquid before its emergence from a bulk mouth of a radiator. Add cooling liquid in a broad tank to the minimum tag.
Close a radiator stopper. Start the engine and warm up it up to the temperature of opening of the thermostat, at the same time cooling liquid will begin to pass through a radiator. The radiator and the top hose of a radiator will begin to heat up.
Switch off the engine and wait until it cools down. Add cooling liquid before its emergence from a bulk mouth of a radiator.
Several times squeeze the top hose of a radiator for removal of air from the cooling system and if necessary add cooling liquid. Establish a radiator cover.
Start the engine, warm up it up to the working temperature and check the cooling system for lack of leaks.