Removal
You carry out removal of a final collector on the cold engine in the following order:
– switch off ignition and disconnect a wire of "weight" from the rechargeable battery;
– release from oxygen sensor wire clips. If the new final collector is established, remove the oxygen sensor.
|
Fig. 3.8. Arrangement of bolts of fastening of the thermofilter of a final collector
|
– turn out bolts
(fig. 3.8)
and remove the thermofilter of a final collector;
– apply the means facilitating them an otvorachivaniye on nuts of fastening of a final collector;
– disconnect a reception exhaust pipe from a final collector;
|
Fig. 3.9. An arrangement of a nut and a bolt of fastening of a support of a final collector about a forward support of the engine
|
– turn out nuts and bolts
(fig. 3.9)
and remove a support of a final collector. On some models about two support of a final collector are established;
|
Fig. 3.10. An arrangement of nuts of fastening of a final collector to a head of the block of cylinders
|
– turn out nuts
(fig. 3.10)
and remove a final collector and laying.
Installation
You make installation in the following order:
– remove with a scraper the remains of old laying and adjournment of soot from privalochny surfaces of a final collector and a head of the block of cylinders;
– establish new laying of a final collector on hairpins of a head of the block of cylinders;
– establish a final collector and fix it by nuts. Tighten nuts in several approaches, since the center and further on a spiral.
Further installation is carried out to the sequences, the return to removal.
Launch the engine and check for lack of leak of the fulfilled gases.