Removal
You make removal in the following order:
– switch off ignition and disconnect a wire of "weight" from the rechargeable battery;
– take off a belt of the drive of hinged units;
– tighten the parking brake and block back wheels an emphasis;
– weaken nuts of fastening of the right forward wheel. Lift a forward part of the car and establish on support. Remove the right forward wheel and an antisplash guard of an arch of the right forward wheel;
|
Fig. 3.85. Use of special device for fixing of a pulley / quencher of fluctuations from a provorachivaniye and an otvorachivaniye of the central bolt
|
– install the special adaptation fixing it from a provorachivaniye on a pulley / quencher of fluctuations, and a face key with a big shoulder turn out the central bolt
(fig. 3.85)
;
– screw the central bolt on several rounds of a carving and a stripper remove a pulley/quencher of fluctuations from a bent shaft. Turn out the central bolt and remove a pulley / quencher of fluctuations from the car.
PREVENTION
Do not use a stripper which captures are established on an external surface of a pulley / quencher of fluctuations as it will lead to its damage.
|
Installation
You make installation in the following order:
|
Fig. 3.86. An arrangement of a spline of a bent shaft for fixing of a pulley / quencher of fluctuations
|
– manually establish as far as possible a pulley / quencher of fluctuations on a bent shaft of the engine, at the same time combine a shponochny groove on a pulley with a spline of a bent shaft
(fig. 3.86)
;
– install the special adaptation fixing it from a provorachivaniye on a pulley / quencher of fluctuations, and a face key with a big shoulder screw the central bolt and tighten its moment 170 N • m.
You carry out further installation to the sequences, the return to removal.