Fill in engine oil and cooling liquid.
Turn out from the engine of a spark plug and disconnect the electric socket of giving of tension to the fuel pump.
Starter turn a bent shaft of the engine until the control lamp of pressure of oil goes out.
Screw spark plugs and connect the electric socket of giving of tension to the fuel pump.
Launch the engine. Perhaps, launch of the engine will be more long as time for creation of pressure in fuel system will be required.
Warm up the engine up to the working temperature. In process of warming up of the engine you watch closely possible emergence of leak of oil, fuel or cooling liquid. Emergence of unusual smells and smoke from the details which are affected by high temperature because of burning out of the remains of oil is allowed.
Stop the engine and check levels of engine oil and cooling liquid and if necessary add.
If new pistons, piston rings, radical and connecting rods were installed, then the engine has to pass a running in throughout the first 800 km of a run. In the period of a running in operation with completely open butterfly valve or with too small speed on any transfer is not allowed.
After a running in replace engine oil and an oil filter.
After the run of 3000 km replace engine oil and an oil filter again.