You make removal of a cable of an accelerator as follows:
Switch off ignition and disconnect a wire of "weight" from the rechargeable battery.
|
Fig. 5.22. Weakening of a lock-nut of fastening of a cover of a cable to throttle knot
|
Weaken a lock-nut of fastening of a cover of a cable to throttle knot
(fig. 5.22)
.
Turn the lever of throttle knot and a needle or passatizha remove an accelerator cable from a groove in the lever.
Disconnect an accelerator cable from an accelerator pedal.
Take an accelerator cable from a partition in a motor compartment.
You carry out installation of a cable of an accelerator to the sequences, the return to removal. Make sure that before installation of a cable of an accelerator in a partition of a motor compartment the condensing ring is established.
For adjustment of a cable of an accelerator execute the following:
– turn off an adjusting nut on 3 mm from a cable arm;
– eliminate any sagging of a cable;
– tighten a lock-nut and check a cable deflection accelerators between the lever of throttle knot and a cover of a cable which has to make 9–12 mm. If the deflection goes beyond the specified limits, weaken a lock-nut and, rotating an adjusting nut, establish the required deflection;
– after adjustment of a cable of an accelerator, the assistant has to press and release an accelerator pedal, at the same time the lever of throttle knot has to turn from an emphasis against the stop. Check that the cable of an accelerator moves smoothly, without jammings.