Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
   General information
   Technical characteristics
   System of onboard Diagnostics (OBD)
   Information sensors and executive stroystvo
   Codes of malfunctions of the OBD-II system
   Control unit of the engine (PCM)
   Sensors and valves of system of injection of fuel (EFI)
   System of compulsory ventilation of Carter (PCV)
   System of recirculation of the fulfilled gases (EGR) on models since 2001
   System of catching of vapors of fuel (EVAP)
   Catalytic converter
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment

Toyota RAV4>> The control system and decrease in toxicity of the fulfilled gases>> Catalytic converter
On models since 2001 of release catalytic converter is combined with a final collector.
On all cars catalytic converters for reduction of amount of the harmful substances released into the atmosphere with the fulfilled gases are established.
Inlet and final cones with branch pipes and fixing flanges, and also the heatreflectors holding a ceramic covering are welded on the converter case made of stainless steel. All internal volume of the case is busy with the ceramic porous monolith catalyst recorded by rings or a grid from stainless steel. The catalyst represents the filter in which all internal and external surface of the time contacting to gases is covered with very thin layer of alloy which contains platinum, rhodium and palladium. The porous catalyst has big surface area, covered with this alloy from very expensive metals that generally and determines the high price of catalytic converters.
In the catalyst there is a reaction as a result of which potentially dangerous hydrocarbon and carbon monoxide in the fulfilled gases turn into safe gases and water vapor.
You make replacement of catalytic converter as follows:
– for simplification of an otvorachivaniye of nuts of compound of catalytic converter previously impregnate them with the liquid weakening connections;

Fig. 7.31. Catalytic converter on models till 2001: 1 – right support of a final collector; 2 – clamp; 3 – pillow; 4 – laying; 5 – laying; 6 – laying; 7 – reception exhaust pipe; 8 – thermal insulation; 9 – oxygen sensor (block 1, sensor 2); 10 – forward part of catalytic converter; 11 – thermal insulation; 12 – right casing of the engine; 13 – oxygen sensor (block 1, sensor 2); 14 – a forward part of catalytic converter with thermal insulation

Fig. 7.32. Catalytic converter on models since 2001: 1 – top thermal insulation; 2 – lower thermal insulation No. 1; 3 – laying; 4 – sensor of fuel-air mix (block 1, sensor 1); 5 – oxygen sensor (block 1, sensor 2); 6 – support of a final collector; 7 – support of a final collector; 8 – lower thermal insulation No. 2; 9 – oxygen sensor (block 2, sensor 2); 10 – a final collector with catalytic converter; 11 – sensor of fuel-air mix (block 2, sensor 1)

– turn out nuts and separate catalytic converter from system of production of the fulfilled gases (fig. 7.31, 7.32) .
You make installation in the sequence, the return to removal.