Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
   General information
   Shaft of the drive of forward wheels
   Shaft of the drive of back wheels on all-wheel drive cars
   Replacement of protective covers of hinges of a shaft of the drive of a wheel
   Basic bearing of the driveshaft
   Sealing cuffs of reverse main gear
   Differential on all-wheel drive cars
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment

Toyota RAV4>> Driveshaft and shaft of the drive of driving wheels>> Replacement of protective covers of hinges of a shaft of the drive of a wheel>> Installation
Wrap up vents of the internal end of a shaft of the drive an adhesive tape not to damage a protective cover about sharp sides of shliyets of a shaft.
Pull a collar and a protective cover over a drive shaft.
Establish трипоид on vents of a shaft of the drive and fix it by a lock ring. Grease трипоид and the internal surface of the case of the hinge. Insert the hinge into the case and fill it with the lubricant remains.
Put on a protective cover the hinge, at the same time check that seats of a cover were established in the grooves intended for them.

Fig. 10.8. Place of measurement of length of a shaft of the drive

Measure the drive shaft length which has to correspond to length specified in specifications (fig. 10.8) .
Fix a protective cover by collars, the screw-driver previously having raised an inner edge of a cover for alignment of pressure of air under a cover.

Fig. 10.9. Use of the special tool for fastening of a collar: 1 – protective cover; 2 – special tool; 3 – collar clip

The special tool (fig. 10.9) is necessary for fixing of collars . Establish sponges of the tool on corners of a clip of a collar and in this situation tighten sponges the screw.
Install a drive shaft on the car.