Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
   General information
   Anti-blocking system of brakes (ABS)
   Replacement of front brake shoes
   Replacement of a support of a forward brake
   Check and replacement of brake disks
   Replacement of back brake shoes
   Replacement of the working brake cylinder
   Replacement of the main brake cylinder
   Replacement of sealing rings of a tank of the brake system
   Replacement of brake tubes and hoses
   Pumping of the hydraulic drive of brakes
   Check and replacement of the vacuum amplifier of brakes
   Adjustment of the parking brake
   Replacement of cables of the parking brake
   Adjustment of provision of a pedal of a brake
   Check and replacement of the switch of a stoplight
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment

Toyota RAV4>> Brake system>> Replacement of the main brake cylinder>> Removal
On models till 2001 uncover the air filter and the block of safety locks and the relay on the left side of a motor compartment.

Fig. 11.35. Main brake cylinder: And – the electric socket; In – places of connection of brake tubes; With – nuts

Disconnect the electric socket from the sensor of level of brake fluid ( fig. 11.35 ).
Uncover a compensation tank of the brake system and, using the syringe, pump out brake fluid.
Mark the brake tubes suitable to the main brake cylinder. Put pure rags under the main brake cylinder for collecting the leaked brake fluid.
Turn off connecting nuts of fastening of brake tubes and take tubes aside from the main brake cylinder. Close the ends of tubes suitable traffic jams.

The brake fluid used in hydraulic system of brakes is poisonous therefore at hit it on skin immediately wash out an affected area a large amount of water. Brake fluid dissolves paint and plastic therefore at hit of liquid on a paint and varnish covering of the car wash out its large number waters.

Turn out two nuts and remove the main brake cylinder from the vacuum amplifier of brakes together with laying. Check a condition of a sealing ring in an end face of the main brake cylinder and if necessary replace it.