Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
   General information
   Anti-blocking system of brakes (ABS)
   Replacement of front brake shoes
   Replacement of a support of a forward brake
   Check and replacement of brake disks
   Replacement of back brake shoes
   Replacement of the working brake cylinder
   Replacement of the main brake cylinder
   Replacement of sealing rings of a tank of the brake system
   Replacement of brake tubes and hoses
   Pumping of the hydraulic drive of brakes
   Check and replacement of the vacuum amplifier of brakes
   Adjustment of the parking brake
   Replacement of cables of the parking brake
      Replacement of a back cable
      Replacement of a forward cable
   Adjustment of provision of a pedal of a brake
   Check and replacement of the switch of a stoplight
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment

Toyota RAV4>> Brake system>> Replacement of cables of the parking brake>> Replacement of a forward cable
The forward cable of the parking brake connects the lever of the parking brake to the compensator.
Remove the central console.
Release the lever of the parking brake.

Fig. 11.42. Arrangement of a lock-nut and adjusting nut of the parking brake

Weaken a lock-nut (the top nut), at the same time the second key hold an adjusting nut (the lower nut) from a provorachivaniye, then turn off a lock-nut and an adjusting nut (see fig. 11.42 ).
Block forward wheels an emphasis.
Weaken nuts of fastening of a back wheel. Lift a back part of the car and establish it on support.
For access to the compensator of the parking brake remove the thermofilters located over system of production of the fulfilled gases.
Turn a cable of the parking brake on 90 ° and disconnect it from the compensator.
Squeeze out the condensing ring in a trough-shaped element of the bottom of the car and extend a cable through the opened opening.
You make installation in the sequence, the return to removal, taking into account the following.
Grease a back part of a cable of the parking brake and connect it to the compensator.
Before installation of the condensing ring apply a sealant layer that through it water did not get into interior of the car on its edges.
Adjust a cable of the parking brake.