Tighten the parking brake and block back wheels an emphasis.
Weaken nuts of fastening of a forward wheel. Lift a forward part of the car and establish it on support. Remove a forward wheel.
Turn out a bolt of fastening of an arm of a brake hose to a rack of a forward suspension bracket. In the presence of ABS turn out bolts of fastening of clips of wires and separate a plait of wires of the sensor from a rack.
On models since 2001 disconnect draft of the stabilizer of cross stability from an arm on a rack.
Note the mutual provision of the lower part of a rack and a rotary fist that at installation not to break wheel disorder. Also note the provision of heads of bolts because on a part of cars special adjusting bolts were established.
Fig. 12.1. Otvorachivaniye of nuts of fastening of the lower part of a rack of a forward suspension bracket to a rotary fist
Turn off two nuts and the hammer and a drift beat out two bolts of fastening of the lower part of a rack to a rotary fist
Separate the lower part of a rack from a rotary fist.
Be careful not to damage the internal CV JOINT of a power shaft. Also prevent falling of a rotary fist outside of the car, it can lead to stretching or a rupture of a brake hose.
Fig. 12.2. An arrangement of nuts of fastening of the top part of a rack of a forward suspension bracket to a car body
Supporting a rack from below, turn out three nuts of fastening of the top part of a rack to a body of the car
. Take a rack from under a car wing.