When performing spackling works it is necessary to have the wide flexible plastic or nylon pallet for giving of smoothness of a surface of hard putty. When working on a shpaklevaniye of a body adhere to the following recommendations:
Level hard putty on the damaged site of a body so that to give it the required form and smoothness.
As soon as it was succeeded to achieve approximately required contour, stop smoothing down hard putty the pallet as at too long smoothing down it will begin to harden, stick on the pallet and to roll down therefore the surface will be damaged.
You apply the subsequent, more thin film of hard putty, only after drying of the previous layer and so until the level of hard putty does not begin to act slightly over the processed site.
After hard putty hardening remove its surplus with a metal scraper or a file.
You make further processing, using at the first stage a coarse-grained emery paper, then fine-grained. An emery paper have on flat wooden whetstone, otherwise it will be impossible to achieve a plain surface.
On a closing stage of grinding the waterproof emery paper should be moistened with water periodically. It will give to the processed puttied surface special smoothness.
The puttied dent has to be surrounded on perimeter with a layer of pure metal. For removal of dust and fats wash out the processed site water and wipe with the degreasing means.
Raise dust on the site a thin layer of light soil. It will help to reveal all defects allowed when processing in hard putty. Level them by means of a new layer of hard putty and again to a zashkurta a surface.
After that the field of repair is ready to final painting.
Aerosol putting paint has to be carried out in the warm, dry, windless and easy atmosphere.
When carrying out painting indoors moisten half of the working platform with water for prevention of hit in dust air. When coloring only of one panel, other parts of a body have to be covered from hit of paint on them with the newspaper attached by an adhesive tape.
Before putting primer carefully mix it, apply on a trial surface and achieve that she laid down evenly. Put a thick layer of primer for what apply several thin films.
Polish the grounded surface a waterproof emery paper. At the same time do not forget to sprinkle the ground area water and to periodically moisten an emery paper in water.
Before further painting dry up the processed site.
Put a paint coat with a spray. Necessary thickness of a paint coat is reached by drawing several thin layers.
Begin coloring from the center of the processed surface and move to edges back and forth motions until all painted surface and area at distance about 20 mm around it are not painted.
Remove a protective film and newspapers later 10–15 minposl of drawing the last paint coat.
Give the chance to fresh paint to harden within at least two weeks, then by means of an obnovitel of paint or thin abrasive polishing paste even the edges of the painted area to the level of old paint.
Polish a surface.