You carry out removal of a cowl as follows:
Open a cowl and enclose pure rags under its corners to protect a paint and varnish covering of the car at removal of a cowl.
Disconnect a hose and electric sockets from a washer nozzle.
Tie a thin long cord to a hose and the electric socket.
Extend an electrical wiring and a hose from a cowl, untie from them a cord, leave it in a cowl. Further the cord will be required for installation in a cowl of an electrical wiring and a hose.
Fig. 14.1. Arrangement of bolts of fastening of the hinge of a cowl
Ask the assistant to support a cowl in open situation, turn out bolts of fastening of the left and right hinges of a cowl and, being careful, remove a cowl.
You make installation of a cowl in the sequence, the return to removal, taking into account the following:
With two assistants establish a cowl and twirl by hand bolts of fastening of hinges of a cowl.
Level cowl hinges according to earlier made tags and tighten bolts of fastening of a cowl.
You make adjustment of a cowl as follows:
Close a cowl and check its provision of rather adjacent surfaces. For adjustment weaken bolts of fastening of loops of a cowl and, moving a cowl, adjust its situation.
After adjustment tighten bolts of fastening of loops of a cowl.
It must be kept in mind that the bolts established at the plant do not allow to carry out adjustment therefore for performance of adjustment replace these bolts standard with flat lock washers.
Marker note position of hinges on a cowl to have an idea on what distance to move a cowl.
After adjustment close a cowl and check its provision of rather adjacent surfaces.
For adjustment of a forward part of a cowl on height, and also for adjustment of gaps between a forward part of a cowl and wings it is possible to change position of the lock of a cowl.
Fig. 14.2. Arrangement of bolts of fastening of the lock of a cowl
Marker note the provision of bolts of fastening of the lock of a cowl
. Weaken bolts and, moving the lock, install it in situation at which gaps between a forward part of a cowl and wings will be identical and uniform on all length.
After adjustment tighten bolts of fastening of the lock of a cowl.
You carry out adjustment of height of installation of a forward part of a cowl, rolling or turning out the rubber emphasis located on each side on the forward cross panel on models till 2001 and in a forward part of a cowl on models since 2001 and also adjustment of position of the lock of a cowl. For increase in height of installation of a cowl rotate a rubber emphasis clockwise, and for reduction — counterclockwise.