Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
   General information
   Technical characteristics
   Electric chains
      Detection of damages to a chain
      Electric sockets
   Check of the rechargeable battery
   Replacement of wires of the rechargeable battery
   Safety locks and relay
   Check and replacement of the relay of indexes of turn and alarm light system
   Check of system of charging
   System of launch of the engine
   Replacement of the combined understeering switches
   Replacement of the lock and cylinder of the lock of ignition
   Removal and installation of switches of the dashboard
   Removal and installation of a combination of devices
   Check and replacement of the engine of a screen wiper
   Radio receiver and loudspeakers
   Replacement of the antenna
   Check and repair of a heater of back glass
   Replacement of lamps in headlights
   Adjustment of light of headlights
   Replacement of a headlight
   Sound signal
   Replacement of glow lamps
   Check of the drive of external rear-view mirrors
   Check of system cruise control
   Check of window regulators with the electric drive
   Check of system of the central blocking of locks
   Drive of the lifting and movable panel of a roof
   Safety cushions
Schemes of electric equipment

Toyota RAV4>> Electric equipment>> Electric chains>> Electric sockets
The majority of connections in electric network of the car is executed by multicontact sockets in the plastic case. Sections (half) of sockets after connection usually are kept by the clamps cast in the socket case.
Sections of the big sockets, for example, installed under the dashboard connect together the screw passing through the center of the socket.
To disconnect the socket with a clamp, the small screw-driver wring out a clamp(s), then disconnect the required socket section. Attentively examine the socket as often clamps of sockets are imperceptible at first sight. Many sockets have on some clamps.

At separation of the socket do not pull socket section in different directions for wires as it is possible to damage or pull out wires from clips of contacts of the socket.