You make removal of the switch of the alarm light system on models till 2001 as follows:

Fig. 15.24. Use of the screw-driver for separation from the dashboard of the switch of the alarm light system

Using a screw-driver edge as the lever, separate the switch of the alarm light system and take it from the dashboard ( fig. 15.24 ).

Disconnect the electric socket, wring out a clamp and take the switch from a casing.

Removal of the switch

alarm light system

on models since 2001

It is made as follows.

Fig. 14.51. An arrangement of screws of fastening of the central overlay of the dashboard on models since 2001

Turn out screws and remove the central slip from the dashboard (see fig. 14.51 ).

Fig. 15.25. Arrangement of screws of fastening of the control unit of a heater

Turn out screws and extend the control unit of a heater from the dashboard, then disconnect the electric socket from a back part of the switch ( fig. 15.25 ). Wring out a clamp and take the switch from a casing.

You make installation of the switch of the alarm light system in the sequence, the return to removal.