Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
   General information
   Technical characteristics
   Electric chains
   Check of the rechargeable battery
   Replacement of wires of the rechargeable battery
   Safety locks and relay
   Check and replacement of the relay of indexes of turn and alarm light system
   Check of system of charging
   System of launch of the engine
   Replacement of the combined understeering switches
   Replacement of the lock and cylinder of the lock of ignition
   Removal and installation of switches of the dashboard
   Removal and installation of a combination of devices
   Check and replacement of the engine of a screen wiper
   Radio receiver and loudspeakers
      Removal and installation of the radio receiver
      Removal and installation of broadband loudspeakers
      Removal and installation of high-frequency loudspeakers
   Replacement of the antenna
   Check and repair of a heater of back glass
   Replacement of lamps in headlights
   Adjustment of light of headlights
   Replacement of a headlight
   Sound signal
   Replacement of glow lamps
   Check of the drive of external rear-view mirrors
   Check of system cruise control
   Check of window regulators with the electric drive
   Check of system of the central blocking of locks
   Drive of the lifting and movable panel of a roof
   Safety cushions
Schemes of electric equipment

Toyota RAV4>> Electric equipment>> Radio receiver and loudspeakers>> Removal and installation of the radio receiver
You make removal of the radio receiver as follows.
Switch off ignition and disconnect a wire of "weight" from the rechargeable battery.

Fig. 15.35. An arrangement of screws of fastening of finishing of the radio receiver on models till 2001

On models till 2001 turn out screws and remove the panel of finishing of the radio receiver ( fig. 15.35 ).
On models since 2001 remove the central overlay of the dashboard.

Fig. 15.36. Arrangement of screws of fastening of the radio receiver

Turn out screws and extend the radio receiver for access to the electric sockets and the plug of the antenna located from a reverse side of the radio receiver ( fig. 15.36 ). Disconnect electric sockets and the plug of the antenna, and remove the radio receiver from the car.
You make installation of the radio receiver in the sequence, the return to removal.