Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
   General information
   Technical characteristics
   Electric chains
   Check of the rechargeable battery
   Replacement of wires of the rechargeable battery
   Safety locks and relay
   Check and replacement of the relay of indexes of turn and alarm light system
   Check of system of charging
   System of launch of the engine
   Replacement of the combined understeering switches
   Replacement of the lock and cylinder of the lock of ignition
   Removal and installation of switches of the dashboard
   Removal and installation of a combination of devices
   Check and replacement of the engine of a screen wiper
   Radio receiver and loudspeakers
   Replacement of the antenna
   Check and repair of a heater of back glass
   Replacement of lamps in headlights
   Adjustment of light of headlights
   Replacement of a headlight
   Sound signal
   Replacement of glow lamps
   Check of the drive of external rear-view mirrors
   Check of system cruise control
   Check of window regulators with the electric drive
   Check of system of the central blocking of locks
   Drive of the lifting and movable panel of a roof
   Safety cushions
Schemes of electric equipment

Toyota RAV4>> Electric equipment>> Check of the drive of external rear-view mirrors

Fig. 15.59. Arrangement of components of management of external rear-view mirrors: 1 – the electric motors located in cases of mirrors; 2 – the ECU block located from the forward passenger; 3 – ignition lock; 4 – switch of adjustment of provision of external mirrors; 5 – the block of safety locks from the driver

For adjustment of provision of each external rear-view mirror 2 electric motors are used: one for adjustment in vertical, the second — in horizontal the planes ( fig. 15.59 ).
The switch has the selector which gives tension on the right or left mirror.
You make check of the drive of external rear-view mirrors as follows.
Include ignition, without launching the engine. Lower windshields and serially turn mirrors in the vertical and horizontal planes, listening to a sound of the working engines.
If the engine works, and the mirror does not move, perhaps, the mirror drive mechanism is faulty. Remove and sort a mirror for definition of a cause of defect.
If mirrors do not move and is not heard operation of engines, check integrity of a safety lock.
If the safety lock is serviceable, remove the switch from the dashboard and check its state.
According to electric circuits check reliability of connection of wires of the mirrors connected to "weight".
If the mirror still does not work, remove it and check giving of tension to a mirror.
If there is no tension even in one position of the switch, check an electric chain between a mirror and the switch.
If tension is present at all working provisions of the switch, remove a mirror and check operability of electric motors, connecting them additional wires to the rechargeable battery. If engines do not work, replace a mirror.