Cars are equipped with security systems (SRS) including safety cushions and natyazhitel of seat belts. Before work about sensors of blow, the dashboard and a steering column disconnect at first negative, and then positive plugs from the rechargeable battery and wait 2 min. It will exclude unauthorized disclosure of safety cushions and operation of natyazhitel of seat belts which can put injuries.
You make removal of the lock of a cowl as follows:
Fig. 14.2. Arrangement of bolts of fastening of the lock of a cowl
Marker note the provision of bolts of fastening of the lock of a cowl (see
). Turn out bolts and remove the lock from the forward cross panel.
Fig. 14.3. A cable cover detachment from the cowl lock case
Disconnect a cable cover from the case of the lock of a cowl and a cable from a latch of the lock
You make installation in the sequence, the return to removal, taking into account the following: adjust position of the lock so that gaps between a forward part of a cowl and wings were identical, and a rubber emphasis when closing a cowl slightly contracted.
You make removal of a cable of opening of the lock of a cowl as follows:
In interior of the car remove the upholstery panel located under the dashboard from the driver.
Fig. 14.4. A cable detachment from the handle of opening of a cowl: And — the place of fastening of a cover of a cable; In — the place of fastening of a cable to the squeezing lever; With — a clamp
Lift the handle of opening of a cowl up and disconnect a cable cover from a handle arm, then disconnect a cable from the squeezing lever
If squeezing the lever with the handle are replaced, pull the handle outside and press for removal from a clamp and its detachment from the dashboard down.
Tie a thin long cord to a cable. Further the cord will be required for retraction to the place of a cable of opening of a cowl.
In a motor compartment disconnect a cable and a cover of a cable from the cowl lock. Release a cable from clips on a forward cross beam and along a wing.
Extend a cable in a motor compartment, before emergence of a cord, then untie a cord from an old cable and fix it on a new cable.
For a cord stretch a new cable through a partition of a motor compartment until it reaches the handle of opening of a cowl, then untie a cord.
In interior of the car connect a cable to the squeezing lever, and fix a cover of a cable on a handle arm.
If at installation of a cable the condensing ring was displaced from a partition of a motor compartment, establish by fingers of a hand it into place.
You make further installation in the sequence, the return to removal.