Jack you make a pull of the car as follows:
– install the car on the flat horizontal platform with a hard coating;
– tighten the parking brake and include the 1st transfer on cars with the mechanical transmission or install the selector lever in a position "P" on cars with the automatic transmission;
– from outside, opposite lifted, block a wheel an emphasis;
Fig. 1.37. Points of installation of a jack when raising the car
– get a jack from under the right front seat and establish it so that its pillow was under one of the following points
1. When replacing a forward wheel — back fastening of the lever of a forward suspension bracket.
2. When replacing a back wheel — the lever of a back suspension bracket;
Be convinced of correctness of installation of a jack, otherwise it is possible to damage the car.
Do not work under the car if it is supported only by a jack.
Do not lift the car with passengers.
– rotating the jack handle, lift the car.
If the car rises for replacement of a wheel, lift it only on height sufficient for removal of a wheel;
– after completion of all works remove a jack;
– before a start of motion be convinced that all tools and a jack are laid on the place and are reliably fixed for an exception of injuries in case of collision and at sharp braking.
For an exception of damage of the bottom and falling of the car, establish elevator support only in the recommended places.
Do not start the engine and do not include transfer on the lifted car if at least one wheel of the car is on the earth.
Do not lift the car for the oil pallet, the transmission and forward or back axes as at the same time the car can be damaged.